Guide

THE TOOLBOX / CARPENTRY & CONSTRUCTION

Stair Calculator —
Stringer Layout, 1/16" Cuts & IRC Code Check.

Compute exact stair riser height to the nearest 1/16 inch, total run, bottom riser drop cut, 2×12 stringer length, throat depth, and IRC R311.7 headroom compliance.

Exact Riser
7 11/16"
7.714" × 14 risers
Total Run
136 1/2"
13 treads @ 10.5"
Stringer Board
16 ft
Hypotenuse 169.4"
Stair Angle
36.3°
Throat: 5.03"
IRC R311.7 Code
✓ CODE PASS
2R+T = 25.9"

Staircase Dimensions (Inches)

Side-Elevation Stringer Layout & Framing Square Guide

Total Run: 136.5" (136 1/2") · Angle 36.3°Rise: 108"
Bottom Riser Drop Cut: Trim 1" off the bottom of the stringer so your first cut riser is 6 11/16" (6.714"). Once the 1" tread is installed, every step matches at 7 11/16".
Max Riser Height (≤ 7-3/4")7 11/16" ✓
Min Tread Depth (≥ 10")10 1/2" ✓
Min Throat Depth (≥ 3.5")5.03" ✓
Min Headroom (≥ 80")83.9" ✓

CARPENTRY & CODE REFERENCE

IRC R311.7 residential stair dimensions and framing square tips.

1. Measure Finished-to-Finished

Always include finished flooring thickness on both landings when measuring Total Rise. Even a 3/4" hardwood floor added later can trigger an IRC 3/8" riser variance failure.

2. The Blondel Comfort Rule (2R + T)

Well-proportioned stairs satisfy 2 × Riser + Tread = 24" to 25" with a slope between 30° and 37°. Steeper stairs feel cramped; shallower stairs disrupt natural stride rhythm.

3. Don't Forget the Bottom Drop Cut

After laying out all steps on your 2×12 with stair gauges on your framing square, rip the exact tread thickness off the bottom plumb line so Step #1 matches Steps #2–N.

Frequently Asked Questions

How do I calculate stair stringer rise and run?

Measure the exact vertical Total Rise from finished lower floor to finished upper floor. Divide Total Rise by your target riser height (typically 7" to 7.5") and round to a whole number of risers. Divide Total Rise by that riser count for the exact cut riser height, then multiply the number of treads by your tread depth (10"–11") for Total Run.

Why do I subtract tread thickness from the bottom of a stair stringer?

Every step receives a tread board on top, which raises the walking surface by the tread thickness—except the floor at the bottom. Subtracting one tread thickness (e.g., 1" interior or 1.5" deck board) from the bottom of the stringer keeps the first step identical in height to all upper steps.

What are the IRC residential building code limits for stairs?

Under IRC R311.7, maximum riser height is 7-3/4 inches (7.75"), minimum tread depth is 10 inches, minimum clear width is 36 inches, minimum headroom clearance is 6 ft 8 in (80 inches), and the greatest riser variance cannot exceed 3/8 inch.

What is the minimum remaining throat depth for a 2×12 stair stringer?

After cutting the triangular step notches into a 2×12 (11.25" actual width), leave at least 3.5 inches (5 inches preferred for exterior decks) of solid uncut lumber along the bottom edge so the stringer does not crack under load.