Guide

Cycling & Moto • Suspension Tuning

Suspension Sag (25%–30%) & Spring Rate Calculator

Enter your suspension travel and measured O-ring movement in millimeters to verify your exact sag percentage, target window, and starting coil spring rate.

Measured Sag Percentage
27.1%
Target window: 35–42 mm
Est. MTB Coil Spring Rate
475 lb/in
Leverage ratio: 2.55:1 • Air fork start: ~91 PSI
Tuning Recommendation: Spot on! Your sag sits right inside the target window.

Recommended Suspension Sag Targets by Riding Style

Related Bike & Gear Calculators

Frequently Asked Questions

How do I measure suspension sag accurately on a mountain bike or motorcycle?

Put on all your normal riding gear (helmet, shoes, hydration pack), open compression damping fully, slide the rubber O-ring to the wiper seal, carefully assume your normal attack/riding posture without bouncing, step off gently, and measure how far the O-ring moved in millimeters.

What is the ideal sag percentage for trail mountain biking?

Most trail and all-mountain riders run 25%–30% sag on the rear shock and 18%–22% sag on the front fork. Cross-country racers prefer firmer 15%–20% sag for pedaling efficiency, while enduro and downhill setups run 28%–33%.

What sag percentage should a street motorcycle vs. dirt bike have?

Street motorcycles typically target 25%–30% rider sag (around 30–35 mm on a 120 mm shock), while motocross and off-road dirt bikes target 30%–33% (roughly 100–105 mm on 300 mm of rear travel).

When should I switch to a stiffer coil spring instead of adding preload?

If you need more than 2–3 full turns of preload collar on a mountain bike coil shock (or more than ~10 mm of preload on a motorcycle) to achieve target sag, step up to the next heavier spring rate.