Guide

THE TOOLBOX / RIGGING, MARINE & OFF-ROAD

Rope & Knot Working Load Calculator —
WLL, Knot Efficiency & Safety Factor Derating.

Never guess a rope’s safe load after tying a knot. Combine Minimum Breaking Strength (MBS), knot efficiency (Figure-8, Bowline, Clove Hitch), wet derating, and a 3:1 to 10:1 safety factor.

Safe Working Load Limit (WLL)
897 lbs
407 kg · 3.99 kN (5:1 safety factor)
Knot-Adjusted Breaking Strength
4,485 lbs
Knot keeps 78% (−1,265 lbs lost)
Rated Straight-Pull MBS
5,750 lbs
Common anchor & dock line.

KNOT EFFICIENCY TABLE

Approximate Rope Strength Retention by Common Knot Type.

Knot / TerminationStrength RetainedBest Use
Eye Splice / Sewn Loop90% – 95%Anchor lines, tow straps, heavy rigging
Figure-8 Loop / Alpine Butterfly75% – 80%High-load loops & climbing / rescue
Bowline~70%Easy-to-untie marine & utility loop
Clove Hitch / Square Knot45% – 62%Light temporary tying only (never heavy loads)

2. Educational Estimate Only

Always follow the manufacturer’s stamped Working Load Limit tag on certified lifting slings and climbing gear, and retire any rope with cuts, glazed melts, or core shots.

Frequently Asked Questions

What is the difference between Breaking Strength (MBS) and Working Load Limit (WLL)?

Minimum Breaking Strength (MBS) is the lab-tested force at which a brand-new, unknotted rope snaps. Working Load Limit (WLL) is the maximum safe everyday load—calculated by dividing MBS (after knot efficiency reduction) by a Safety Factor of 5:1 to 10:1.

How much does tying a knot weaken a rope?

Sharp bends inside a knot concentrate stress on outer fibers, cutting rope strength by 20% to 50%. A Figure-8 Loop retains ~75–80% of rated strength, a Bowline retains ~70%, a Clove Hitch ~60%, and a Square Knot only ~45%.

What safety factor should I use for rigging vs. vehicle towing?

Cordage Institute guidelines recommend 5:1 to 12:1 for general synthetic rope depending on diameter and dynamic shock; 5:1 is common for static utility rigging, 10:1+ for overhead or critical lifting, and recovery tow straps are typically rated at 3:1 (MBS = 3× WLL).

Does wet nylon rope lose strength?

Yes—wet nylon absorbs water and temporarily loses roughly 10% to 15% of its dry breaking strength, while polyester and Dyneema retain full strength when wet.

Why should you NEVER tie a knot in a vehicle recovery tow strap?

Tying a knot in a flat webbing tow strap slashes its strength by up to 50% and cinches permanently tight under a 10,000 lb pull. Always join straps with a rated soft shackle or D-ring shackle instead.

Is this rope and knot working load calculator free?

Yes—calculate knot-derated breaking strength and safe WLL in lbs, kg, and kN instantaneously in your browser.