Guide

THE TOOLBOX / CARPENTRY & FRAMING

Roof Rafter Length Calculator —
Common Rafters, Birdsmouth Cuts, Plumb Angles & Truss Count.

Calculate exact gable or shed rafter lengths to the nearest 1/16 inch—including ridge board deduction, overhang tail, safe birdsmouth cut depth, stock lumber length, and rafter count.

Presets:
6/12 (26.6°)
Rafter Cut & Framing Specs (6/12 Pitch)Buy 16' Lumber
Total Cut Length
14' 10 1/16"
Common 13' 4 3/16" + Tail 1' 5 7/8"
Total Rise / Run
5' 11 5/8"
over 11' 11 1/4" run
Rafters Needed
38
19 pairs / trusses @ 16" OC
Total Rafter: 14' 10 1/16"Run: 11' 11 1/4"Rise5' 11 5/8"Birdsmouth (3.5" seat)Tail: 1' 5 7/8"
Plumb Cut: 26.6° (Speed Sq: 6)Birdsmouth Heel: 1.75" (max 2.42")

FRAMING MULTIPLIERS

Roof Pitch Angles & Rafter Slope Multipliers (Per Foot of Run).

Roof PitchAngle (Deg)Multiplier (ft/ft)Rafter per 1' Run
4 / 1218.4°1.054112.65"
6 / 1226.6°1.118013.42"
8 / 1233.7°1.201914.42"
10 / 1239.8°1.301715.62"
12 / 1245.0°1.414216.97"

Frequently Asked Questions

How do you calculate roof rafter length from span and pitch?

For a gable roof, divide the building span in half to get the horizontal run (subtracting half the ridge board thickness, usually 0.75"). Multiply the run by the slope factor √(1 + (pitch/12)²) to find the common rafter length from ridge to outside wall plate, then add the sloped overhang tail length.

What is a birdsmouth cut and how deep can it safely be?

A birdsmouth is the right-angle notch cut into the bottom of a rafter—consisting of a horizontal seat cut and vertical heel cut—so the rafter sits solidly on top of the wall plate. Building codes (IRC) limit the birdsmouth notch depth to no more than one-third (1/3) of the rafter’s vertical depth to preserve structural strength.

What is the difference between a plumb cut and a seat cut?

A plumb cut is vertical when the rafter is installed (used at the ridge peak, the birdsmouth heel, and the fascia tail). A seat cut (level cut) is horizontal when installed (resting flat on the wall top plate). On a framing speed square, both angles align directly with your pitch number on the Common scale.

How many rafters or trusses do I need for my roof?

Divide your building length in inches by your on-center spacing (16" OC or 24" OC), round up, and add 1 for the final gable end. For a standard gable roof framed with stick rafters, multiply that number by 2 (one rafter per side).

Why do I subtract 3/4 inch from the run for a 2x ridge board?

A standard nominal 2× ridge board has an actual thickness of 1.5 inches. Because each rafter butts against one face of the ridge board rather than meeting at the exact centerline, deducting half the ridge thickness (0.75") from the horizontal run ensures the wall-plate birdsmouth lands accurately.