1. Related Home & DIY Calculators
Plan your next build with our Cornhole Board Dimensions Guide, Fish Tank Floor Load Calculator, Bed Mattress Guide, and Paint Coverage Calculator.
THE TOOLBOX / HOME & GARAGE DIY
Estimate exact gallons of epoxy primer, 100% solids or water-based base coat, clear urethane topcoat, and decorative vinyl flakes for your garage or basement shop floor.
COVERAGE REFERENCE CHART
| Target Thickness | Theoretical Coverage | 2-Car Garage (440 sq ft) | Typical Use Case |
|---|---|---|---|
| 8 mils | 200 sq ft / gal | ~2.5 gal | Light basement / storage floor |
| 12 mils | 133 sq ft / gal | ~4.0 gal | Standard residential garage |
| 16 – 20 mils | 80 – 100 sq ft / gal | ~5.5 – 6.5 gal | Heavy workshop / commercial bay |
Plan your next build with our Cornhole Board Dimensions Guide, Fish Tank Floor Load Calculator, Bed Mattress Guide, and Paint Coverage Calculator.
90% of peeling garage floors trace back to poor concrete prep. Perform a 24-hour plastic-sheet moisture test first and diamond-grind or acid-etch until water beads soak into the slab immediately.
A standard 2-car garage (20×22 ft = 440 sq ft) coated at 12 mils with 100% solids epoxy needs roughly 3.5 to 4 gallons of base epoxy (including 10% waste), plus ~2 gallons of epoxy primer and ~1.5–2 gallons of clear urethane topcoat.
One US gallon of 100% solids liquid epoxy covers 1,604 square feet at 1 mil (0.001 inch) thickness. Divide 1,604 × Solids% by your target mil thickness to find theoretical sq ft per gallon—for example, 100% solids at 12 mils covers ~133 sq ft/gal before concrete porosity.
Water-based garage kits are typically 40–50% solids—half the volume evaporates as water, leaving a thin 2–4 mil film that can peel under hot tires. 100% solids commercial epoxy cures at full thickness (10–16 mils) with far higher abrasion and chemical resistance.
For a light sprinkle, plan ~1 lb per 160 sq ft; for a medium garage broadcast, ~1 lb per 65 sq ft (about 7 lbs for a 2-car garage); for a full "rejection" granite-look broadcast, plan ~0.12 lbs per sq ft (~50–55 lbs for a 2-car garage, sweeping up excess).
Concrete is porous and traps air in microscopic capillaries. Rolling a thin primer coat seals pores first so trapped air doesn’t bubble up ("outgassing") through your thick colored epoxy base coat.
Yes—calculate exact gallons of primer, base coat, topcoat, color flakes, and DIY cost instantly in your browser.