1. Solar Array Wattage
Array Watts = Daily Wh ÷ (Peak Sun Hours × System Efficiency). Use ~80%–85% efficiency to account for panel heat derating, wiring losses, and MPPT conversion.
THE TOOLBOX / SOLAR & ENERGY
Size your solar panel array, LiFePO4 or AGM battery bank (12V/24V/48V), pure sine inverter, and MPPT charge controller from your daily kWh usage and local peak sun hours—100% privately.
SOLAR SIZING FORMULAS
Array Watts = Daily Wh ÷ (Peak Sun Hours × System Efficiency). Use ~80%–85% efficiency to account for panel heat derating, wiring losses, and MPPT conversion.
Battery kWh = (Daily kWh × Autonomy Days) ÷ (0.92 × DoD), then divide watt-hours by your system voltage (12V, 24V, or 48V) to get Amp-hours (Ah).
Size your continuous pure sine wave inverter to at least 1.25× your peak simultaneous wattage so refrigerator compressors, pumps, and microwaves start smoothly without tripping overload protection.
Controller Amps = (Total Array Watts ÷ Battery Voltage) × 1.25. Moving from 12V to 48V cuts required amperage by 75%.
Auditing household power consumption? Pair this with our Electricity Cost Calculator or Unit Converter.
Divide your daily watt-hours by (Peak Sun Hours × System Efficiency). For example, an 8 kWh/day (8,000 Wh) load with 4.5 peak sun hours and 82% efficiency requires 8,000 ÷ (4.5 × 0.82) ≈ 2,168 W—or six 400 W solar panels.
Peak Sun Hours measure the equivalent number of hours per day when solar irradiance averages 1,000 W/m²—not total daylight hours. Most US and temperate regions average 3.5 to 5.5 peak sun hours/day (higher in sunny deserts, lower in cloudy northern winters).
Lead-acid and AGM batteries should typically only be discharged to 50% Depth of Discharge (DoD) to preserve cycle life, whereas LiFePO4 lithium iron phosphate batteries safely deliver 80%–90% usable capacity—cutting total required battery kWh and weight nearly in half.
Use 12V for small camper vans under ~1,500 W inverter loads, 24V for medium cabins up to ~3,000 W, and 48V for whole-home or heavy off-grid systems above 3,000 W to minimize cable thickness, current (amps), and MPPT controller costs.
Divide total solar array watts by battery bank voltage and multiply by a 1.25 safety factor: MPPT Amps = (Array Watts ÷ Battery Volts) × 1.25.