Guide

THE TOOLBOX / CYCLING & WHEELBUILDING

Bike Spoke Length Calculator —
Exact ERD, Hub Flange & 2x / 3x / Radial Wheelbuilding Math.

Calculate exact left and right bicycle spoke lengths from rim ERD, hub flange PCD, center-to-flange offset, and lacing cross pattern—with dish tension balance and interactive lacing diagram.

Wheel Builds:
Left Side (Non-Drive / Rotor)
Right Side (Drive / Cassette)
Calculated Spoke LengthsTension Balance: 54%
Left (Non-Drive) · 16 spokes
292.9 mm
Order: 293mm (or 292mm even)
Right (Drive) · 16 spokes
290.1 mm
Order: 290mm (or 290mm even)

3-Cross Lacing Geometry

3-cross lacing transfers braking and drivetrain torque tangentially. Rear wheels and disc-brake front wheels should always use 2x or 3x lacing.

Dish differential: 2.8 mm (Left longer)

WHEELBUILDING REFERENCE

Typical Rim ERD Ranges & Lacing Guidelines.

Wheel SizeISO Bead SeatTypical Rim ERDCommon Lacing
700c / 29er (Shallow)622 mm598 – 608 mm28H / 32H · 3-Cross
700c Aero Carbon (50mm deep)622 mm538 – 548 mm24H · 2-Cross
650b / 27.5"584 mm560 – 568 mm28H / 32H · 3-Cross
26" MTB / Touring559 mm535 – 544 mm32H / 36H · 3-Cross

1. Standard 3D Spoke Length Formula

L = √((R − r·cos α)² + (r·sin α)² + d²) − (h ÷ 2), where R = ERD ÷ 2, r = Flange Dia ÷ 2, α = 720° × Crosses ÷ Spoke Count, d = Center-to-Flange Offset, and h = Spoke Hole Diameter.

Frequently Asked Questions

What is ERD (Effective Rim Diameter) and how do I measure it?

ERD is the diameter measured from the nipple seat on one side of the rim to the opposite nipple seat—specifically where the spoke ends should sit (usually the bottom of the nipple screwdriver slot). Measure it by threading two 200mm spokes into opposite holes with nipples, measuring the gap between spoke ends, and adding 400mm.

Should I round spoke length up or down when ordering?

Most wheelbuilders round to the nearest 1mm (or round down by up to 0.5mm on thin double-butted spokes like 2.0/1.5/2.0mm, which stretch slightly under 100–120 kgf tension). Avoid spokes more than 1.5mm too long, as threads can bottom out before reaching proper tension.

Why are drive-side rear spokes shorter than non-drive-side spokes?

On a rear cassette hub, the right (drive-side) flange sits closer to the wheel centerline to make room for the cassette. Because the drive-side spokes stand more vertically (smaller center-to-flange offset), they are typically 1.5–2.5mm shorter and carry higher tension.